Sony WM-D6C Manual de usuario

OPERATING INSTRUCTIONSPlease read this operating manual thoroughly before operating this high quality electronic unit, so that you can obtai

FUNCTIONS TO MAKERECORDING/PLAYBACKEASYMIC ATT (attenuator) switchThe microphone attenuator-is useful for recording a large input signal on

HOW TO USE THE CARRYING CASE AND SHOULDER STRAP11

MAINTENANCESPECIFICATIONSCLEANING THE HEADSClean the heads after every 10 hours of use toenjoy optimum hi-fi stereo sound: moisten a cotton swa

Outputs LINE OUT (stereo minijack) x1output level 0.25 V (less than 4.7 kilohms)Headphones (stereo minijack) xiload impedance 8-300 ohms Power output

PARTS IDENTIFICATION0 0 0O Peak/battery indicator and indication selector0 Tape counter and reset button O DOLBY NR selector O TAPE selector0 REC LEVE

OWNER’S RECORDTABLE OF CONTENTSThe model number is located at the rear and • the serial number is located in the battery compartment.Record the serial

FEATURESPRECAUTIONS• Quartz lock capstan servo system assures accurate and stable tape speed.• In addition to the conventional B-type Dolby * *

BATTERY INSERTIONInsert four batteries, size AA (lEC designation R6), with correct polarity, referring to the illustration below.Note: Wh

ICASSETTE INSERTIONTake up any slack in the tape with a thick pencil, and insert a cassette with the desired side up. Avoid touching t

PLAYBACKCONNECTIONFor playback through the headphonesto LINE OUTFor playback through speakers^ R f f LI I to TAPE or AUXred plug: to right channelwhit

SPEED TUNE SELECTOR AND CONTROLThe playback speed can be adjusted to tune the pitch of a tape, recorded on another tape recorder. Set t

RECORDINGCONNECTIONNotes• To connect a stereo microphone with two L and R miniplugs or two microphones with a miniplug, use an optional

OPERATION1 Insert a cassette.2 Set the TAPE selector to the appropriate position.3 For recording with Dolby B-type NR process, set t